Toro Z Master Z597 - Replacing the Fan Pump Drive Belt; Replacing and Tensioning the Alternator Belt

5-29Z Master Z597 Diesel Service Manual
5
Fig 324 DSC-2581
2. Pull the spring loaded idler down and remove the
fan pump drive belt from the engine and pump pulley
(Fig. 324).
Fig 323 DSC-2580
Check the fan pump drive belt for wear after every 50
hours of operation.
1. Loosen the bolts and remove the rear engine panel
(Fig. 323).
3. Install the new belt around the engine and hydro
pump pulley.
4. Pull the spring loaded idler down and align the belt.
Release the pressure on the spring loaded idler (Fig.
325).
Fig 325 DSC-2583
Check the alternator belt for wear after every 50 hours of
operation.
ENGINE
Replacing the Fan Pump Drive Belt
Replacing and Tensioning the
Alternator Belt