4-28 Z Master Z597 Diesel Service Manual
4
HYDRAULIC SYSTEM
Fig 210 m-6280 1
4. To make the machine go right, turn the knob towards
the right side of the machine (Fig. 210).
5. To make the machine go left, turn the knob towards
the left side of the machine (Fig. 210 above).
6. Repeat adjustments until the tracking is correct.
1. Pump rod 3. Tracking knob
2. Turn this way to 4. Turn this way to
track left track right
Note: Cleanliness is a key factor in successful ow
testing of the hydraulic system. Thoroughly
clean all exposed surfaces prior to any type
of maintenance. Cleaning all parts by using
a solvent wash and air drying is usually
adequate. As with any precision equipment,
all parts must be kept free of foreign material
and chemicals. Protect all exposed sealing
areas and open cavities from damage and
foreign material.
1. Lift the back of the unit so the rear tire (left or right)
is off the ground. Place jack stands under the rear
frame to support the unit. Remove the rear tire; in
this case the left rear tire is removed (Fig. 211).
Note: Be careful not to place jack stands near
any moving parts or areas not capable of
supporting the weight of the machine.
Hydraulic Flow Testing Procedure
Fig 211 DSC-2573
To Next Page
Loading...
