7-24 Z Master 597 Diesel Series Service Manual
7
Mower Spindle Assembly
1. Install the spacer through the top of the spindle
housing (Fig. 472).
Fig 472 DSC-2688
2. Using a press, install the upper bearing race into the
spindle housing (Fig. 473).
Note: The wider inside diameter of the bearing race
should be facing up to accept the tapered
bearing.
Fig 473 DSC-2689
MOWER DECKS
A. Bearing Race B. Spacer
Fig 471 DSC-2684
15. This view shows the 2 bearing races and the large
spacer in the spindle housing (Fig. 471). Note the
internal snap ring in the housing; it is not necessary
to remove it when installing new bearing races and
the spacer.
A
B
A
To Next Page
Loading...
