7-25Z Master 597 Diesel Series Service Manual
7
MOWER DECKS
Fig 476 DSC-2692
5. Install the lower seal (Fig. 476).
Note: The open lip of the seal should be facing
outward.
Fig 474 DSC-2690
3. Turn the spindle housing over and install the lower
bearing race into the spindle housing (Fig. 474).
Note: The wider inside diameter of the bearing race
should be facing up to accept the tapered
bearing.
Fig 475 DSC-2691
4. Pack the tapered bearing with #2 grease and install
the tapered bearing (Fig. 475).
6. Using a seal driver, drive or press the seal on the
lower end of the spindle housing until the seal is
ush with the outer edge of the housing (Fig. 477).
Fig 477 DSC-2693
To Next Page
Loading...
