7-46 Z Master 597 Diesel Series Service Manual
7
1. Position mower on a at surface.
2. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Check the tire pressure of all four tires. If needed,
adjust to 13 psi (90 kPa).
Leveling the Mower
22. Install the mower spindle belt; refer to Mower
Spindle Belt, page 7-39.
23. Install the rear bumper and tighten the 4 bolts (Fig.
556).
Fig 556 DSC-2595
Setting up the Machine
MOWER DECKS
20. Connect the electric PTO clutch harness to the
wiring harness (Fig. 554).
Fig 554 DSC-2601
21. Pull the spring loaded idler bracket down and install
the fan pump drive belt (Fig. 555)
Fig 555 DSC-2596
To Next Page
Loading...
