Toro Z Master Z597 - Wheel Motor Installation

4-10 Z Master Z597 Diesel Service Manual
4
HYDRAULIC SYSTEM
10. Swing the brake linkage forward out of the way of
the wheel motor. It may be necessary to loosen the
back two bolts to remove the spacers (Fig. 150).
Fig 150 DSC-2113
12. For service work on the wheel motor refer to the
Parker/Ross Service Manual, Form #492-4753.
Fig 151 DSC-2114
11. Remove the back two bolts, lock washers, spacers,
and nuts and remove the wheel motor from the
frame (Fig. 151).
Wheel Motor Installation
Note: As a reminder, prior to connecting the
hydraulic lines, the O-Rings should be
replaced with new ones and lightly lubricated
with petroleum jelly.
Note: There are two different spacers used on the
wheel motors (Fig. 152). The short spacers
are used in the front of the wheel motor (with
the brake linkage) and the long spacers are
used to retain the back of the wheel motor.
Fig 152 DSC-2117
A
B
A. Short Spacer B. Long Spacer