Toro Z Master Z597 - Motion Control Assembly Removal

3-29Z Master Z597 Diesel Service Manual
3
CHASSIS
1. Remove both oor pan assembly hinge bolts (Fig.
109).
Motion Control Assembly Removal
Fig 109 DSC-1686
2. Remove oor pan assembly (Fig. 110).
Fig 110 DSC-1689
Fig 108 DSC-1685
11. Raise mower deck to the transport position. Remove
support blocks. Check deck level adjustment (refer
to the Leveling the Mower procedure, pg 7-46).
Readjust compression spring length by turning front
nut. Spring should be compressed to a length of
11-1/2” (29.2cm) between washers. Lock the front
nut into position by tightening the spring jam nut
(Fig. 108).
12. Untie the oor pan assembly and lower. Return
motion control lever to its neutral locked position.