Toro Z Master Z597 - Page 126

6-5Z Master 597 Diesel Series Service Manual
6
ELECTRICAL
5. Verify that there is continuity between the
appropriate terminals in the ON and OFF positions
(Fig. 347).
Cont.
OFF (IN) ON (OUT)
not used
Cont.
Open
Open
Cont.
Cont.
Open
Open
not used
Y
Y
Y
Y
N
N
N
N
Fig 347 PTO switch test
6. Replace the switch if your test results do not
correspond with those given in Fig. 347.
7. Mount the PTO switch back into the control panel
and reinstall the wiring harness (Fig. 348).
Violet
Orange
GrayGray
Gray
Orange
Orange
Fig 348 PTO clutch switch
Fig 349 DSC-2519
The ignition switch is located on the control panel, to the
left side of the operator (Fig. 349).
The ignition switch provides the proper switching for the
starter, accessories, and safety circuits.
Purpose
IGNITION SWITCH
Location
Continuity?
Y = Yes
N = No