7-3Z Master 597 Diesel Series Service Manual
7
5. Disconnect the electric clutch harness from the
wiring harness (Fig. 391).
Fig 391 DSC-2601
6. Remove the bolt, spacer, washers and nut retaining
the clutch brake strap to the frame (Fig. 392).
Fig 392 DSC-2604
Fig 394 DSC-2651
8. Insert a 12” long 3/8” drive extension into the square
hole of the idler bracket. Use a 3/8” drive ratchet on
the extension and pull back to relieve spring tension
on the idler bracket. Remove the mower drive belt
from the spring loaded idler pulley and outer PTO
clutch sheave (Fig. 394).
Fig 393 DSC-2650
7. On the left side of the unit is the spring loaded idler
pulley for the mower drive belt. Note the square cut
hole in the idler bracket (Fig. 393).
MOWER DECKS
Note: Rear tire removed for clarity.
To Next Page
Loading...
