Toro Z Master Z597 - Page 56

4-3Z Master Z597 Diesel Service Manual
4
HYDRAULIC SYSTEM
6. Remove the case drain hydraulic hose, located on
the left hand side of the hydrostatic pump (Fig. 124).
Note: When removing hydraulic hoses from the
pump, cap the hose and the tting on the
hydrostatic pump. This is to make sure dirt
and debris does not enter these areas.
Fig 124 DSC-2083
Note: Before removing the hydraulic lines from
the hydrostatic pump, mark or tag one of the
hoses to make sure they are reconnected
correctly.
Fig 126 DSC-2088
8. Remove the hydraulic suction line from the top of the
hydrostatic pump (Fig. 126). Install caps on the
hydraulic line and on the ttting.
Fig 125 DSC-2087
7. Remove the two hydraulic hoses on the bottom of
the hydrostatic pump that go to the hydraulic motor
(Fig. 125). Install caps on the hydraulic hoses and
ttings.