1. PRODUCT OVERVIEW
ENGLISH VERSION
EO1-33094
1.1 Introduction
E1- 1
1. PRODUCT OVERVIEW
1.1 Introduction
1.2 Features
1.3 Unpacking
Thank you for choosing the TOSHIBA B-EX4T2 series bar code
printer. This Owner’s Manual contains from general set-up
through to how to confirm the printer operation using a test print,
and should be read carefully to help gain maximum performance
and life from your printer. For most queries please refer to this
manual and keep it safe for future reference. Please contact your
TOSHIBA TEC representative for further information concerning
this manual.
This printer has the following features:
• The print head block can be opened providing smooth loading
of media and ribbon.
• Various types of media can be used as the media sensors can
be moved from the centre to the left edge of the media.
• Web based functions such as remote maintenance and other
advanced network features are available.
• Superior hardware, including the specially developed 8
dots/mm (203 dots/inch) thermal print head which will allow very
clear print at a printing speed of 3, 6, 10, or 12 inches/sec. and
3, 5, 8, 10, or 12 inches/sec. with 11.8 dots/mm (300 dots/inch)
thermal head. 23.6 dots/mm (600 dpi) thermal print head which
will allow very clear print at a printing speed of 2, 3, 4, 5, or 6
inches/sec.
• Besides the optional Cutter Module, there is also an optional
Peel off Module, RS-232C I/F card, Centronics I/F card,
Expansion I/O Card, Wireless LAN I/F card, the RTC/USB host
I/F card, HF band RFID mount kit and Narrow width platen kit.
Unpack the printer as per the Unpacking Instructions supplied with
the printer.
To Next Page
Loading...
Need help?
General
