Toshiba B-EX4T2 SERIES - Printer Setting

2. PRINTER SETUP ENGLISH VERSION EO1-33094
2.6 Printer Setting
E2-14
2.6 Printer Setting
Depending on the settings of your host computer or the interface
being used it may be necessary to change the printer parameter
settings.
Follow the procedures described below to change the printer
parameter settings to correspond to your environment.
NOTE:
Incorrect settings can cause the printer not to function correctly. If
you have any problems with the parameter settings, please contact
your nearest TOSHIBA TEC service representative.
For the settings this manual does not cover, please contact your
nearest TOSHIBA TEC service representative, or refer to the B-EX4T
Series Key Operation Specification manual.
ONLINE Mode
User System Mode
Power ON
[PAUSE]
PAUSE state
Hold down [RESTART]
Power OFF
Hold down [MODE]
• Reset
• Parameter setting (⇒Section 2.6.2)
• Fine adjustment (⇒Section 2.9)
• LAN/WLAN (⇒Section 2.6.3)
• BASIC (⇒Section 2.6.4)
• Z-MODE (⇒Section 2.6.5)
• Auto calibration (⇒Section 2.6.6)
• Dump mode (⇒Section 2.6.7)
• Log (⇒Section 2.6.8)
System Mode
Turn on the power while holding
down [FEED] & [PAUSE] or
[MODE].
• Self diagnosis
• Parameter setting
• Fine adjustment
• Test print (⇒Section 2.8)
• Sensor adjustment
• RAM clear
• Interface setting (⇒Section 2.6.10)
• BASIC mode
• RFID setting
• Real Time Clock (⇒Section 2.6.11)
• Z-MODE
• USB memory (⇒Section 2.6.12)
• Reset