2. PRINTER SETUP ENGLISH VERSION EO1-33094
2.6 Printer Setting
E2-15
2.6 Printer Setting
(Cont.)
2.6.1 User System Mode
Key functions in system mode
Key Function
[MODE] Returns to the system mode menu.
[CANCEL] or
[FEED]+[RESTAR]
Returns to the previous menu.
Displays the next screen. [ENTER] or
[PAUSE]
Saves the settings and returns to the
previous menu.
Moves the cursor up.
(Note 1)
[UP] or [RESTART]
Increases a value.
(Note 2)
Moves the cursor down.
(Note 1)
[DOWN] or [FEED]
Decreases a value.
(Note 3)
[LEFT] Moves the cursor to the left.
(Note 3)
[RIGHT] Moves the cursor to the right.
(Note 3)
How to enter the User System Mode
The User System Mode consists of the following menus.
<1>RESET
Used to reset the printer.
<2>PARAMETER SET (⇒ Section 2.6.2)
Used to set the printer parameters.
<3>ADJUST SET (⇒ Section 2.9)
Used to fine adjust the print start position, cut position, etc.
<4>LAN/WLAN (⇒ Section 2.6.3)
Used to enable or disable the LAN communication and SNMP.
<5>BASIC (⇒ Section 2.6.4)
Used to set the function of basic program when it is loaded to
the printer.
<6>Z-MODE (⇒ Section 2.6.5)
Same as BASIC
<7>AUTO CALIB (⇒ Section 2.6.6)
Used to enable or disable the automatic calibration function.
<8>DUMP MODE (⇒ Section 2.6.6)
Used to print the data in the receive buffer for debugging
purposes.
<9>LOG (⇒ Section 2.6.7)
Used to save print logs in USB memory.
NOTES:
1. The cursor will not scroll from the bottom to the top or top to bottom
of a menu.
2. The value will not increase or decrease any further than the maximum
or minimum values of a parameter.
3. The cursor will not move any further than the left- or right-most
positions of a field.
4. Any values changed will not become effective if the printer is turned
off without pressing the [ENTER] key.
PAUSE
RESTART
UP
RIGHT
ENTER
DOWN
CANCEL
MODE
LEFT
FEED
ONLINE
User System Mode
[PAUSE] Hold down [RESTART]
Hold down [MODE]
To Next Page
Loading...
