2. PRINTER SETUP ENGLISH VERSION EO1-33094
2.6 Printer Setting
E2-25
2.6.4 Basic Program Setting
2.6.5 Enabling Z-Mode
The following table shows the contents of the Basic program
setting menu.
Contents of the Basic Program Setting Menu
Menu Sub menu
BASIC BASIC
FILE MAINTENANCE
TRACE
EXPAND MODE
(1) BASIC
Select whether to enable the BASIC program.
• OFF
Disables BASIC program.
• ON Enables BASIC program.
(2) FILE MAINTENANCE
The block number and BASIC program file name (up to 12
characters) stored in the BASIC program storage area are
displayed. If the file name exceeds 12 characters, the overflowing
characters are not displayed.
When no file is stored, a hyphen (“-“) is displayed in place of the
file name.
(3) TRACE
Allows you to enable tracing in the BASIC program.
• OFF
Disables tracing the BASIC program.
• ON Enables tracing the BASIC program.
(4) EXPAND MODE
The printer switches the mode to execute the BASIC program.
The Z-Mode menu allows you to select whether or not to enable
the Z-Mode
.
(1) Z-MODE
• OFF
Z-Mode is disabled.
• ON SETTING OFF Z-Mode is enabled. BASIC system mode
program is not started automatically.
• ON SETTING ON Z-Mode is enabled. BASIC system mode
program is started automatically.
USER SYSTEM MODE
<3>ADJUST SET
<4>LAN/WLAN
<5>BASIC
<6>Z-MODE
USER SYSTEM MODE
<2>PARAMETER SET
<3>ADJUST SET
<4>LAN/WLAN
<5>BASIC
To Next Page
Loading...
Need help?
General
