2. PRINTER SETUP ENGLISH VERSION EO1-33094
2.8 Print Test
E2-59
2.8 Print Test
After your operating environment has been set, perform a print
test.
1. Perform a print test by using the Printer Driver or an Issue
Command.
The printer driver’s Properties screen allows you to set the
communication conditions, media size, and other printing
conditions in accordance with your operating environment. For
details, refer to the Help for the Windows Printer Drivers
screen.
Example: Stock tab display of the Printer Driver’s Properties Screen
Print Method: Direct thermal or thermal transfer is
selectable.
Sensor: Media sensor type is selectable.
Issue Mode: Batch, strip or cut is selectable.
Post-print
Action:
Whether to use the cutter or not is
selectable.
Fine
Adjustment:
Adjustment values for the feed amount,
cut/strip position, etc. can be set.
2. Confirm the print test result.
• When a print start position, cut/strip position, or print tone
needs to be adjusted: ⇒ Section 2.9 Position and Print
Tone Fine Adjustment
• When pre-printed media is used, and if a print start position is
not properly detected: ⇒ Section 2.10 Threshold Setting
Print Method
Senso
To Next Page
Loading...
Need help?
General
