2. PRINTER SETUP ENGLISH VERSION EO1-33094
2.8 Print Test
E2-60
2.8 Print Test (Cont.)
When using a Strip Module or an optional Cutter Module
It is necessary to set the issue mode, cut/strip position, etc. on the
Printer Driver or with TPCL (TEC Printer Command Language) in
accordance with your printing condition.
For details of the TPCL, refer to the B-EX4T/EX6T Series
External Equipment Interface Specification.
Regarding how to use the Printer Driver, refer to the Help for the
Windows Printer Drivers screen.
To gain maximum performance and life from the Cutter Module or
Strip Module, periodic cleaning is required.
Before starting a cleaning, be sure to TURN OFF the printer to
avoid risk of injury.
For details of cleaning, refer to Section 4.1.3 Optional Cutter
Module.
To Next Page
Loading...
