Toshiba B-EX4T2 SERIES - Page 104

7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33094
7.1 Media
E7-２
7.
Max.
effective
print width
Max. 104.0 +-0.2 104.0 +-0.2 104.0 +-0.2
Min. 6.0 15.0 17.0 6.0 15.0 17.0 3.0 8.0 17.0
Label
Max. 1496.0 1496.0 1492.0 1496.0 1496.0 1492.0 496.0 496.0 492.0
Min. 8.0 － 19.0 8.0 － 21.4 5.0 － 19.0
8.
Effective
print length
Tag
Max. 1498.0 － 1498.0 1498.0 － 1498.0 498.0 － 498.0
Slow-up 1.0 1.0 1.0
9.
Slow-up and
down area
(Un-print
area)
Slow-down 1.0 1.0 1.0
Min. 0.13 0.13 0.13
10.
Paper
thickness
Max. 0.17 0.17 0.17
Min. - 0.08 - 0.08 - 0.08
11.
Paper
thickness
can be cut
Max. - 0.17 - 0.17 - 0.17
12. Max. paper roll diameter
φ200
(Using external rewinder φ180)
φ200
(Using external rewinder φ180)
φ200
(Using external rewinder φ180)
13. Paper winding direction
Inside the printing side
(STD.)
Inside the printing side
(STD.)
Inside the printing side
(STD.)
14. Paper core
Inside diameter
φ76.2±0.3
Inside diameter
φ76.2±0.3
Inside diameter
φ76.2±0.3
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. When using the peel-off at 12”/sec or more for 203dpi model, issue at 10”/sec.
When using the peel-off at 10”/sec or more for 300dpi model, issue at 8”/sec.
3. When using the disk cutter, the label length must meet the following condition:
Label length 18.0mm - (Gap length/2).
4. The Strip Module do not support the print speed of 10”/sec. or faster.
5. The ratio of a label length to a gap length must be a minimum of 3 to 1 (3:1).
6. When using label stock in cut mode, be sure to cut in the gaps. Cutting labels will cause the adhesive
to stick to the cutter, which may affect the cutter performance and shorten the cutter life.
7. When the Strip Module is used on the GS12 (203 dpi) model, the print speed is automatically corrected
to 10”/sec. if 12”/sec. or faster is specified.
When the Strip Module is used on the TS12 (300 dpi) model, the print speed is automatically corrected
to 8”/sec. if 8”/sec. or faster is specified.