2.PRINTER SETUP ENGLISH VERSION EO1-33094
2.11 Sensor Setting
E2-72
2.11 Sensor Setting
(Cont.)
(1) REFLECT
1. Select “REFLECT” from the Sensor Adjust menu.
2. Place the tag paper to be used on the reflective sensor so
that the sensor can detect a print area.
3. Hold down the [ENTER] for 3 seconds or more.
4. When registration of the “print area level” is completed,
“Adjust Complete” is displayed and an asterisk is shown on
the right side of the voltage.
(2) TRANS.
1. Select “TRANS.” from the Sensor Adjust menu.
2. Remove some labels and place the backing paper so that
the Transmissive sensor can detect it.
3. Hold down the [ENTER] for 3 seconds or more.
4. When registration of the “label gap level” is completed,
“Adjust Complete” is displayed and an asterisk is shown on
the right side of the voltage.
(3) PE REFL./TRANS.
1. Select “PE REFL./TRANS.” from the Sensor Adjust menu.
2. Remove any media from the media sensor.
3. Hold down the [ENTER] for 3 seconds or more.
4. When registration of the “no media level” is completed,
“Adjust Complete” is displayed and an asterisk is shown on
the right side of the voltage.
To Next Page
Loading...
