e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 10
E712 RADF jam Jam not reaching the registration sensor: The
original fed from the original feeding tray does not
reach the registration sensor.
P. 8-105
E714 Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
P. 8-105
E721 Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
P. 8-106
E722 Jam not reaching the exit sensor (during scanning):
The original which passed the read sensor does not
reach the exit sensor when it is transported from the
scanning section to exit section.
P. 8-106
E724 Stop jam at the registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached this
sensor.
P. 8-107
E725 Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its
leading edge has reached this sensor.
P. 8-107
E726 Transport/exit signal reception jam: RADF receives
the transport/exit reception signal from the
equipment when no original is at the exposure
waiting position.
P. 8-108
E731 Stop jam at the exit sensor: The trailing edge of the
original does not pass the exit sensor after its
leading edge has reached this sensor.
P. 8-108
E860 RADF jam access cover open: The RADF jam
access cover has opened during RADF operation.
P. 8-109
E870 RADF open jam: RADF has opened during RADF
operation.
P. 8-109
E871 Cover open jam in the read ready status: Jam
caused by opening of the RADF jam access cover
or front cover while the RADF is waiting for the
scanning start signal from the equipment. (MR-
3021/3022)
P. 8-110
E910 Finisher jam
(Bridge unit)
Jam at the bridge unit transport sensor-1: The
paper does not reach the bridge unit transport
sensor-1 after it has passed the exit sensor.
P. 8-111
E920 Stop jam at the bridge unit transport sensor-1: The
trailing edge of the paper does not pass the bridge
unit transport sensor-1 after its leading edge has
reached the sensor.
P. 8-111
E930 Jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-1.
P. 8-112
E940 Stop jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-2.
P. 8-112
E950 Job separator jam Jam not reaching the job separator transport
sensor: The paper has passed through the exit
sensor does not reach the job separator transport
sensor.
P. 8-113
E951 Stop jam at the job separator transport sensor: The
trailing edge of the paper does not pass the job
separator transport sensor.
P. 8-113
Error code Classification Contents Troubleshooting
トラブルシューティングの内容がEX-Loire2のため、別途修正します。
To Next Page
Loading...
