1. Easy Setup Flow
18 Network Administration Guide — Setup Flow for Printing Features
Setup procedure
1. Setting up the TCP/IP and the HTTP Network Service to
enable TopAccess.
You should set the TCP/IP and HTTP Network Service from the Touch Panel
Display the first time you use it, to make TopAccess available.
z User Function Guide
4. SETTING ITEMS (ADMIN)
3. SETTING NETWORK FUNCTIONS
Setting the TCP/IP Protocol
Setting the HTTP Network Service
z TopAccess Guide
7. TopAccess Administrator Mode
Setting up from TopAccess
Setting up Network Settings
Setting up the TCP/IP
Setting up the HTTP Network Service
2. Setting up the SMB Session.
The NetBIOS name and workgroup should be configured to enable SMB
printing. Also if the network system uses the WINS server to provide name
resolution for this equipment with the Windows network, you can specify the
WINS server to be used.
z User Function Guide
4. SETTING ITEMS (ADMIN)
3. SETTING NETWORK FUNCTIONS
Setting the SMB Protocol
z TopAccess Guide
7. TopAccess Administrator Mode
Setting up from TopAccess
Setting up Network Settings
Setting up the SMB Session
3. Advise users to install the Client Software for SMB printing.
Users can install the printer drivers for SMB printing using the following
methods: 1) Point and Print installation, 2) installation from the Client Utilities
CD-ROM, or 3) Add Printer Wizard installation. It is recommended for an
administrator to determine which method should be used for an installation (or
allows both installations for users.) For more information about the SMB
installation, please see the Printing Guide.
In the SMB enabled network, users must install following client software for
printing:
• Printer Drivers
• TopAccessDocMon
• Agfa Font Manager
To Next Page
Loading...
Need help?
General
