1. Easy Setup Flow
Network Administration Guide — Setup Flow for Printing Features 21
When you want to manage all print jobs in the print server instead of directly printing to
this equipment, the Windows Client Server network solution is helpful. In this case, an
administrator sets up the sharing printer using Raw TCP or LPR in Windows NT 4.0,
Windows 2000, Windows XP, or Windows Server 2003 print server. Then clients can
install the printer driver from the Windows print server using SMB.
Setup procedure
1. Setting up this equipment for Raw TCP or LPR printing.
Please see the setup flow for Raw TCP or LPR printing.
P.16 "Setup Flow for Raw TCP or LPR Printing"
NOTE: When installing the printer driver in the server to set up the sharing printer, install the
printer driver by the Add Printer Wizard. Do not install the printer driver using the
installer.
2. Setting up the Windows print server.
P.59 "Setting up Windows Print Server"
3. Advise users to install the Client Software for SMB printing
via the Windows print server.
Users can install the printer drivers for Windows Client Server network from the
queue created in the Windows print server. This installation method is common
for Windows print sharing. Please refer to the Windows documentation for
information about sharing printers.
In the Windows Client Server network, users must install following client
software for printing:
• Printer Drivers
• TopAccessDocMon
• Agfa Font Manager
Setup Flow for Novell Printing
This equipment supports Novell printing for Windows computers.
System Requirements
Novell printing applies the following NetWare server and client computers:
NetWare NetWare 4.x bindery emulation mode
NetWare 4.x NDS mode
NetWare 5.x and 6.x NDS mode (over IPX/SPX only)
NetWare NDPS Printer Agent
Client OS: Windows 98 (Windows 98 Second Edition Recommended)
Windows Me
Windows NT 4.0 Service Pack 5
Windows 2000 Service Pack 3
Windows XP Service Pack 1
Windows Server 2003
To Next Page
Loading...
