3 Tests and Diagnostics 3.24 Floppy Disk Drive Utilities
3-54 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
3. COPY program
(a) When COPY is selected, the following message appears:
FLOPPY DISK FORMAT & COPY : VX.XX
Type select (0:2DD,3:2HD) ?
(b) Selecting a media/drive type number will display a message similar to the one below:
Insert source disk into drive A:
Press any key when ready.
(c) Remove the Diagnostics Disk from the FDD, insert the source disk and press any
key. The following message will appear, indicating the program has started.
[ FDD TYPE ] : TRACK = XXX
[ FDD TYPE ] : HEAD = X
[ FDD TYPE ] : SECTOR = XX
Copy start
[[ track,head = XXX X ]]
(d) The following message will appear.
Insert target disk into drive A:
Press any key when ready.
(e) Remove the source disk from the FDD, then insert a formatted work disk and press
any key. The following message will appear and start copying to the target disk.
[[ track,head = XXX X ]]
(f) When the amount of data is too large to be copied in one operation, the message
from step (b) is displayed again. After the floppy disk has been copied, the
following message will appear:
Copy complete
Another copy (1:Yes/2:No) ?
(g) To copy another disk, type 1 and the message from step (a) is displayed again.
Entering 2 returns the test program to the DIAGNOSTIC MENU.
To Next Page
Loading...
Need help?
General