4 Replacement Procedures 4.12 Optical drive
4-36 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
2. Remove the following screws and side bracket from the optical drive.
? M2?3C S-THIN HEAD x2
? M2?3.2 Stepping screw x1
Figure 4-25 Disassembling the side bracket
Installing the optical drive
The following describes the procedure for installing the optical drive (See Figure 4-24 and
4-25).
1. Attach the side bracket to the optical drive and secure it with the following screws.
? M2?3C S-THIN HEAD x2
? M2?3.2 Stepping screw x1
2. Insert the optical drive assembly into the slot for the drive and connect it to the
connector CN1810 on the system board.
Stepping screw
M2?3C S-THIN HEAD
Side bracket
To Next Page
Loading...
