Toshiba Tosvert VF-A5 - Output Terminal Selections; Low Speed, Acceleration;Deceleration; Complete, Speed Reach Output Signals

,- - 1= '-
,_,I . -' '- (Terminal Selection Parameter)
I' ,-
, ,-
-
' , ,- ' ,
,-,,- ,_ ,-,
' ,- ' '
,-,,-' ,-,
- -
' ,- ' '
' ,- ' ,-,
- -
Low speed, acceleration/deceleration
complete, speed reach output
signals
Related parameters
IL F I Low-speed signal output frequency
lb,- C 1-11 Ace/dee complete detection band
11-1,- [ 1-11 Speed reach HI frequency
IL,- [HI Speed reach LO frequency
10 l: 0 I - 10 t 3 I Output terminal selections
A signal is output when the output frequency exceeds the set low-speed detection frequeny IL FI.
This can be used as a magnetic brake open/ close signal, etc.
Output frequency
[Hzj ··t· ________________________ j ____________ j ___ _
I br [HI<;-. ·_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_+ ----------- i ___
. .
I H.-[H I
IL.-CHI
0
ST-CC
F-CC
. .
. .
. .
. .
.
.
.
.
------------------ -- --~------------1-----------
. .
. .
.
_J
Low speed output ---
signal
Acceleration/deceleration
complete output signal
_______ ..
Speed reach
______ _.
output signal
* The speed reach signal is also output when a preset speed is reached.
L
L
L
Time[S]
E658051b
*The low speed signal will turn OFF when DC injection braking (refer to G ,- .F' ,- Id b F I) is applied
during a decelerated stop.
Note) The speed reach
signal is output when the frequency is greater than l.'-1,- C :-:I , and turned off
when
it is less than IL ,- [ 1-1 I .
- 64 -