Toshiba Tosvert VF-A5 - Standard Connections; Standard Connection Example

E6580516
6. Standard Connections
Refer to the operation selection explanation (7.4 Operation mode selection, page 45), and parameter list
(page 113).
6.1 Standard Connection Example
I Example 1 I To set run frequency, forward/reverse run, and decelerated stop via the panel.
MCCB
.........
---0 u---..i1
3·phase main circuit ---0..--..0---os
power source ---o..--..n----o
uo--- ......
Vu-----1
Wo----'
In standard configuration, RO and SO
ST
F
R
G/E CC
Operating frequency setting
via the
panel
are connected with jumpers to the main
circuit
terminals. (Only for 30kW and smaller)
{Refer to page18.)
These are jumpered at shipment.
Setting
Parameter group
Parameter Setting value Reference page
c,,- .ut
[ i:Od (Command mode selection)
2or '-I
Note 1)
45
c,,- .ut
F ii 0 d (Frequency setting mode
2or '-I
Nore2)
45
selection)
Note
1) I [ i:Od I set to 2 ···Press [BQ[]to start running.
I [ n 0 d I set to '-I ... Press I PAN EUR EMOTE I. then I RUN I to start running.
* Refer to page 33 "7.2 Basic Operation" for the operation methods.
Note
2) I F n O d I set to 2 ··· The reference frequency can be set only from the operation panel.
I F n O d I set to '-I .. · Press I PANEUREMOTE I . and the reference frequency can be
entered from the operation panel.
Example 2 To set operating frequency via the panel, and forward/reverse run, decelerated stop, and
coast·stop with external signals.
Setting
Parameter group
Parameter
Setting value Reference page
c..-.ut
[ii 0 d {Command mode selection)
I or '-I
Note3)
45
c,,- .ut
F ii 0 d {Frequency setting mode
c'
45
selection)
Note
3) Emergency stop is possible from the panel by pressing I STOP I twice.
'
rr1r1 'I tt I
._ , , ,_, c1 se o ,
..
· Running from operation panel is not possible .
I c nod I set to ..... , ... Press I PANE UR EMOTE I. and running is possible from the
operation
panel by pressing I RUN I .
- 15 -