Toshiba Tosvert VF-A5 - Units Settings

,- - ' ,,_
1_1 I • '-' 1_ (Utility Parameters)
-' •= •=• * Units settings
,_, _,,
Related parameters
ldSP21 Frequency units multiplication factor
Id 5 PF I Frequency display resolution
Id 5 PI= I ACC/DEC time units selection
Id 5 P [ I Current units selection
Id 5 P ._,I Voltage units selection
Each
configurable monitor and parameter display units can be selected by these parameters.
< Frequency units
multiplication factor>
dSPc' setting 0 (OFF)
o.o 1-200
E6580516
By setting Id 5 P 21. the motor speed or load equipment speed can be displayed for all parameters
normally displayed in frequency units.
* When Id SP 21 is set to a value other than 0, the LED display will be the normal display value X
ldSPc'I.
< Frequency display resolution >
dSPF
setting value Resolution LED display
n
1Hz
60.
._,
'
0.1Hz
50.0
I
.
2
0.01Hz
:so.oo
< ACC/DEC time units selection >
dSPc
setting value Resolution LED display
r1
0.1 sec .
1r1 r1
._,
I'-'•'-'
I
0.01sec.
1r1 n1-.
I
I
'-' • '-' '-'
< Current units selection >
dSP[
setting value Function Panel units LED lit
r1
%
%
._,
I
A
None
I
Note) The values of the monitor items that display current and the values of the following parameters will
change according to the setting value.
Electronic thermal protection
level #1, #2 It:-:,- :I le 1-1,- c'I DC injection current Id b [
Stallprotectionlevel#1,#2 IScL :I IScLc'I Overtorquetriplevel IOcL
Low current detection level
<Voltage units selection>
dSP,_,
setting value Function Panel units LED lit
r1
% %
,_,
I
v
None
I
Note) Only the voltage monitor values will change according to this setting. The values of parameters that
are set
in voltage units will always be displayed in V.
- 93 -