Toshiba Tosvert VF-A5 - Input;Output Terminal Response Time Selections

,- - ·= '- '-'I . _, 1_ (Terminal Selection Parameter)
,,_ ·=
,,_'
,-,,_ ,-, _,
,_, ,_ ,_, ,_,
Related parameters
,-,, ,-,,
,_, ·= ,_, ,-,
Input/output terminal response time
selections
E6580516
I II= F I
I II= SFI
IOtOdl
IOtOhl
I II= 'iFI
IOI= 3dl
lot 3hl
Input terminals (R, S1, S2, S3, $4, SS, S6, S7) response time selection
Input terminals
(F, RES, ST) response time selections
Output terminals (RCH,
LOW, FL, OUT) delay times
OUtput terminals (RCH, LOW, FL, OUT) hold times
If noise effects or input contact point chattering results in undesirable or incorrect operation, increase the
terminal response time selections. As the setting value is increased, the response time
will also increase
proportionally.
* When set to I , the response time will be the shortest, and when set to IO O , the response time
will be the max. (approx. 200mS).
* The output terminals can be set separately for the delay time when turning ON, and the output hold time
when turning
OFF.
When the acceleration/deceleration time is 0.1 sec. or less and an analog frequency input
is used, chattering may occur
in the acceleration/deceleration complete signal or low
speed detection signal.
Set the output terminal delay times (filter functions) IO I= 0 di
IOI= tell IOc c'dl IOI= 3dl as mecessaty.
- 65 -