Toshiba Tosvert VF-S15 User Manual

E6582175
F-55
6
Operation example : Remote mode ( cmod=0: (Terminal block))
R
e
m
ote
m
ode
L
oca
l m
ode
ON
OFF
ON
OFF
ON
OFF
Key
Output
frequency
F-CC
Internal
operation
command
L
oca
l m
ode
R
e
m
ote
m
ode
ON
OFF
ON
OFF
ON
OFF
Key
Output
frequency
F-CC
Internal
operation
command
Set frequency at
Remote mode
Setting frequency and start/stop
status are moved to Local mode
when switching from Remote
mode to Local mode.
Motor runs continuously for the
case described on the left.
When switching from Local
mode to Remote mode, setting
frequency and start/stop status
are determined by Remote
mode status.
For the case described on the
left, the motor runs continuously
because the Remote mode is
“run” status.
● To prevent from moving the setting frequency and start/stop status of Remote mode to Local
mode, set  to “”(Disabled). In this case, key is effective only while stopping.
EASY
EASY
EASY

Toshiba Tosvert VF-S15 Specifications

General

Category	Inverter
Control Method	V/f control, Sensorless vector control
Cooling Method	Forced air cooling
Model	Tosvert VF-S15
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat
Communication Options	Modbus RTU
Overload Capacity	150% for 1 minute
Braking Unit	Built-in braking transistor
Output Voltage	3-Phase, same as input voltage
Operating Temperature	-10 to +50°C (14 to 122°F)
Storage Temperature	-20 to 65°C (-4 to 149°F)
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m above sea level
Input Voltage	3-Phase 200 to 240 VAC, 3-Phase 380 to 480 VAC
Weight	Varies depending on model (e.g., 0.8 kg to 16 kg)