E6582175
H-4
8
(Continued)
Item displayed
Panel
operated
LED
display
Communic
ation No.
Description
Communication
Status
sl }}
FD57
The status of signal transmission and reception of
communication are displayed in bits.
receiving or transmitting :
not receiving or not transmitting:
Parts replacement
alarm information
m }}}}i
FE79
The ON/OFF status of each of the cooling fan,
circuit board capacitor, main circuit capacitor of
parts replacement alarm, cumulative operation
time or number of starting are displayed in bits.
ON:
OFF:
Cumulative
operation time
FE14
The cumulative operation time is displayed.
(0.10=10 hours, 1.00=100 hours)
Number of starting
FD32 Number of starting (10000 times)
Default display
mode
The output frequency is displayed (Operation at
60Hz).
8.2.2 Display of detailed information on a past trip
Details on a past trip (of trips 1 to 8) can be displayed, as shown in the table below, by pressing the center of the
setting dial when the trip record is selected in the status monitor mode.
Unlike the "Display of trip information at the occurrence of a trip" in 8.3.2, details on a past trip can be displayed,
even after the inverter is turned off or reset.
Item displayed
Panel
operated
LED display Description
Past trip 1
Past trip 1 (displayed alternately)
Continuous trips
For oca, ocl and err5 the number of times
(maximum of 31) the same trip occurred in succession
is displayed (unit: times). Detailed information is
recorded at the latest value.
Note 8
Note 9
Note 10
}}}}i
Cooling fan
Cumulative
operation time
Control circuit board
capacitor
Main circuit
capacitor
Number of starting
}}
TX: signal
transmitting
RX: signal receiving
MODE
sl
To Next Page
Loading...
Need help?
General
