Toshiba Tosvert VF-S15 User Manual

E6582175
F-137
6
6.36 Integrating wattmeter
f748 : Integrating wattmeter retention selection
f749 : Integrating wattmeter display unit selection
 Function
At the main power off, display unit of integral output power values and whether or not retain integral output
power values are selectable.
The integrating wattmeter display can be cleared by the signal to the input terminal.
Input terminal function 74, 75 (Integrating wattmeter display clear)
Title Function Adjustment range Default setting
f748 Integrating wattmeter retention selection
0: Disabled
1: Enabled
0
f749
Integrating wattmeter display unit selection
Note 1)
0:1=1kWh
1:1=10kWh
2:1=100kWh
3:1=1000kWh
4:1=10000kWh
Depends on
the capacity
(Refer to
section 11.4)
Note 1) The description of the adjustment range is for the conversion of the inverter monitor display.
Refer to the RS485 Communication Function Instruction Manual E6581913, in case of using the
communication options.
6.37 Parameter registration to easy setting mode
f750 : EASY key function selection
f751 to f782 : Easy setting mode parameter 1 to 32
Up to 32 arbitrary parameters can be registered to easy setting mode.
 Refer to section 4.5 for details.

Toshiba Tosvert VF-S15 Specifications

General

Category	Inverter
Control Method	V/f control, Sensorless vector control
Cooling Method	Forced air cooling
Model	Tosvert VF-S15
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat
Communication Options	Modbus RTU
Overload Capacity	150% for 1 minute
Braking Unit	Built-in braking transistor
Output Voltage	3-Phase, same as input voltage
Operating Temperature	-10 to +50°C (14 to 122°F)
Storage Temperature	-20 to 65°C (-4 to 149°F)
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m above sea level
Input Voltage	3-Phase 200 to 240 VAC, 3-Phase 380 to 480 VAC
Weight	Varies depending on model (e.g., 0.8 kg to 16 kg)