E6582175
D-13
4
4.4 Checking the region settings selection
set : Checking the region setting
[Parameter setting]
Title Function Adjustment range Default setting
set
Checking the region setting
0: Start setup menu
1: Japan (read only)
2: North America (read only)
3: Asia (read only)
4: Europe (read only)
1 *
* Default setting values vary depending on the setup menu setting. 1 to 4 are displayed.
Content of region settings
The number displayed when parameter set is read indicates which of the following regions was selected on
the setup menu.
4: eu (Europe) is selected on the setup menu.
3: asia (Asia, Oceania) is selected on the setup menu.
2: usa (North America) is selected on the setup menu.
1: jp (Japan) is selected on the setup menu.
The setup menu is started by setting set=0.
Refer to section 3.1 for details.
Note: 1 to 4set to parameter set are read-only. They cannot be written.
Function
The region selected on the setup menu can be checked.
Also, the setup menu starts and can be changed to a different region.
To Next Page
Loading...
