Toshiba Tosvert VF-S15 User Manual

E6582175
C-3
3
 Values set by each setup parameter
Title Function
eu
(Mainly in
Europe)
usa
(Mainly in
North America)
asia
(Mainly in Asia,
Oceania)
Note 1)

(Mainly in
Japan)
ul/vl/170/
f204 /f213 /
f219 /f330 /
f367 /f814
Frequency
50.0(Hz) 60.0(Hz) 50.0(Hz)
60.0(Hz)
vlv/
f171
Base
frequency
voltage
1, 2
240V
class
230(V) 230(V) 230(V) 200(V)
500V
class
400(V) 460(V) 400(V)
400(V)
pt
V/F control mode
selection
0 0 0
2
f307
Supply voltage
correction
(output voltage
limitation)
2 2 2 3
f319
Regenerative over-
excitation upper
limit
120 120 120 140
f417 Motor rated speed
Refer to section 11.4
Note 1) Excludes Japan.
Note 2) Slide switch SW1 is set to PLC side at default setting. Set it appropriately according to the logic used.
Refer to page B-11 to 13 for details.

Toshiba Tosvert VF-S15 Specifications

General

Category	Inverter
Control Method	V/f control, Sensorless vector control
Cooling Method	Forced air cooling
Model	Tosvert VF-S15
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat
Communication Options	Modbus RTU
Overload Capacity	150% for 1 minute
Braking Unit	Built-in braking transistor
Output Voltage	3-Phase, same as input voltage
Operating Temperature	-10 to +50°C (14 to 122°F)
Storage Temperature	-20 to 65°C (-4 to 149°F)
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m above sea level
Input Voltage	3-Phase 200 to 240 VAC, 3-Phase 380 to 480 VAC
Weight	Varies depending on model (e.g., 0.8 kg to 16 kg)