The typical bidirectional link detection
process is
○
2 →
○
4 →
○
5 , and the typical unidirectional link
detection process is
○
2 →
○
4 →
○
6 .
On the FNFR page, you can enable the DLDP state globally and configure the interval of the
advertisement packets and the port shutdown mode. You can also configure the refresh frequency
of the port states and reset the certain port’s DLDP state manually.
Choose the menu Gvjgtpgv"QCO→"FNFR→"FNFR"to load the following page.
Figure 8-12 DLDP Config
The following entries are displayed on this screen:
" Inqdcn"Eqphki"
FNFR"Uvcvg<"
Enable/Disable the DLDP function globally.
Cfxgt"Kpvgtxcn<"
Config the interval to send advertisement packets, ranging from 1
to 30 seconds. The default value is 5 seconds.
124
To Next Page
Loading...
