Ujwv"Oqfg<"
Once detecting a unidirectional link, the port can be shut down in
one of the following two modes:
Cwvq: In this mode, DLDP generates logs and traps and
shuts down the corresponding port on detecting
unidirectional links, and the DLDP link state transits to
Disable.
Ocpwcn: In this mode, DLDP only generates logs and traps if
it detects unidirectional links, and the operation to shut down
the unidirectional link ports is accomplished by the
administrator.
Ygd"Tghtguj"Uvcvg<"
Enable/Disable the web automatic refresh function.
Ygd"Tghtguj"
Kpvgtxcn<"
Configure the interval to refresh the web page, ranging from 1 to
100 seconds, and the default value is 5 seconds.
" Rqtv"Eqphki"
Rqtv"Ugngev<"
Click the Ugngev" button to quick-select the corresponding port
based on the port number you entered.
Ugngev<"
Select the desired port for configuration. It is multi-optional.
Rqtv<"
Port list of the switch.
FNFR"Uvcvg<"
Enable/Disable DLDP on the selected port.
Rtqvqeqn"Uvcvg<"
Displays the DLDP protocol state.
Nkpm"Uvcvg<"
Displays the state of the links.
Pgkijdqt"Uvcvg<"
Displays the state of the selected port’s neighbor.
Configuration Procedure:
Uvgr" Qrgtcvkqp" Fguetkrvkqp"
1 Enable DLDP globally. Required. On the Gvjgtpgv" QCO→FNFR→FNFR page,
configure DLDP State as Enable under the Global Config tab.
2 Enable DLDP on the
specified port.
Required. On the Gvjgtpgv" QCO→FNFR→FNFR page,
configure DLDP State as Enable on specified port in the Port
Config table.
3 Configure Shut Mode. Optional. On the Gvjgtpgv" QCO→FNFR→FNFR page,
configure the Shut Mode as Auto or Manual under the Global
Config tab.
4 Reset DLDP state. Optional. On the Gvjgtpgv"QCO→FNFR→FNFR page, select
the specified ports or select all the ports in the Port Config
table and click the Tgugv"button to restore their state.
:09" Crrnkecvkqp"Gzcorng"hqt"FNFR"
" Pgvyqtm"tgswktgogpvu"
1. Device A and Device B are connected through two fiber pairs, which are cross-connected, as
shown in Figure 8-13.
125
To Next Page
Loading...
