"
Figure 11-11 Storm Control
The following entries are displayed on this screen:
Uvqto"Eqpvtqn"Eqphki"
Rqtv"Ugngev<"
Click the" Ugngev" button to quick-select the corresponding port
based on the port number you entered.
Ugngev<"
Select the desired port for Storm Control configuration. It is
multi-optional.
Rqtv<"
Displays the port number of the switch.
Dtqcfecuv" Tcvg"
*dru+<"
Select the bandwidth for receiving broadcast packets on the port.
The packet traffic exceeding the bandwidth will be discarded.
Select Disable to disable the storm control function for the port.
Ownvkecuv" Tcvg"
*dru+<"
Select the bandwidth for receiving multicast packets on the port.
The packet traffic exceeding the bandwidth will be discarded.
Select Disable to disable the storm control function for the port.
WN/Htcog" Tcvg"
*dru+<"
Select the bandwidth for receiving UL-Frame on the port. The
packet traffic exceeding the bandwidth will be discarded. Select
Disable to disable the storm control function for the port.
NCI<"
Displays the LAG number which the port belongs to.
Pqvg<"
If you enable storm control feature for the ingress rate limit-enabled port, ingress rate limit feature
will be disabled for this port.
174
To Next Page
Loading...
