Choose the
menu Pgvyqtm"Ugewtkv{→CTR"Kpurgevkqp→CTR"Fgvgev to load the following page.
Figure 13-14 ARP Detect
The following entries are displayed on this screen:
" CTR"Fgvgev"
CTR"Fgvgev<"
Enable/Disable the ARP Detect function, and click the Crrn{
button to apply."
" Vtwuvgf"Rqtv"
Vtwuvgf"Rqtv<"
Select the port for which the ARP Detect function is unnecessary
as the Trusted Port. The specific ports, such as up-linked port,
routing port and LAG port, should be set as Trusted Port. To
ensure the normal communication of the switch, please
configure the ARP Trusted Port before enabling the ARP Detect
function.
Eqphkiwtcvkqp"Rtqegfwtg<"
Uvgr" Qrgtcvkqp" Fguetkrvkqp"
1 Bind the IP address, MAC
address, VLAN ID and the
connected Port number of
the Host together.
Required. On the KR/OCE" Dkpfkpi page, bind the IP
address, MAC address, VLAN ID and the connected Port
number of the Host together via Manual Binding, ARP
Scanning or DHCP Snooping.
2 Enable the protection for the
bound entry.
Required. On the Pgvyqtm" Ugewtkv{→KR/OCE"
Dkpfkpi→Dkpfkpi"Vcdng page, specify a protect type for
the corresponding bound entry.
3 Specify the trusted port. Required. On the Pgvyqtm" Ugewtkv{→CTR"
Kpurgevkqp→CTR"Fgvgev page, specify the trusted port.
The specific ports, such as up-linked port, routing port
and LAG port, should be set as Trusted Port.
4 Enable ARP Detect feature. Required. On the Pgvyqtm" Ugewtkv{→CTR"
Kpurgevkqp→CTR" Fgvgev page, enable the ARP Detect
feature.
210
To Next Page
Loading...
