Chapter 2 Configure Touch P5 as a Router
14
2. Use either the WPS Button method or PIN method.
¾ Option 1: Use the WPS Button (Recommended)
Use this option if your client device has a WPS button.
1 ) Tap the Start WPS button on the screen of your Touch P5, and the WPS button
will show as below during the process.
2 ) Immediately press the WPS button of the client device.
3 ) Success will appear on the above screen, which means the client device has
successfully connected to your Touch P5.
Note: Connection failed will appear if the connection cannot be established within 2 minutes.
¾ Option 2: Use the PIN
Use this option if your client device asks for your Touch P5’s PIN.
1 ) Tap Connect to this router via PIN on the above screen of your Touch P5 to get
the PIN. You can use the default one or generate a new one.
2 ) On the client device, enter your Touch P5’s PIN to connect.
To Next Page
Loading...
