Chapter 3 Configure Touch P5 as a Repeater
70
2 ) The Enable DHCP Server is set to be Auto by default and the function will
automatically turn on or off to assign valid IP addresses to client devices
according to the DHCP server settings of the host network.
If you select On, please configure it manually.
• IP Address Pool: The start and end addresses must be on the same subnet with
the LAN IP. Your Touch P5 will assign addresses within this specified range to its
clients. It is from 192.168.0.100 to 192.168.0.199 by default.
• Address Lease Time: The amount of time in which a DHCP client can lease its
current dynamic IP address assigned by your Touch P5. After the dynamic IP
address expires, the client will be automatically assigned a new dynamic IP
address.
• Default Gateway (Optional): Enter the LAN IP address of your Touch P5.
• Primary/Secondary DNS (Optional): Enter this parameters as provided by your
ISP.
If you select Off, please make sure the DHCP server of your host network is on.
Otherwise, you have to configure the IP address for each client manually.
3 ) Tap Save.
¾ To view the client information:
1 ) Select DHCP Client List.
2 ) You can view the information of connected clients.
¾ To reserve an IP address for a specified client device:
1 ) Select Address Reservation and tap Add to add an address reservation entry
for your device.
To Next Page
Loading...
