Printed in the Federal Republic of Germany TR-Electronic GmbH 2008, All Rights Reserved
06/27/2017 TR - ECE - BA - DGB - 0073 - 07 Page 151 of 155
10.2 General Status Codes
The following table lists the Status Codes that may be present in the General
Status Code field of an Error Response message. The extended status code is
object specific and is defined under the respective object if the object supports further
extended status codes.
HEX notation
Service was successfully performed by the object
specified.
A connection related service failed along the
connection path.
Resources needed for the object to perform the
requested service were unavailable.
See Status Code 0x20, which is the preferred
value to use for this condition.
The path segment identifier or the segment
syntax was not understood by the processing
node.
The path is referencing an object class, instance
or structure element that is not known or is not
contained in the processing node.
Only part of the expected data was transferred.
The messaging connection was lost.
The requested service was not implemented or
was not defined for this Object Class/Instance.
Invalid attribute data detected.
An attribute in the Get_Attribute_List or
Set_Attribute_List response has a non-zero
status.
Already in
requested
mode/state
The object is already in the mode/state being
requested by the service.
The object cannot perform the requested service
in its current mode/state.
The requested instance of object to be created
already exists.
A request to modify a non-modifiable attribute
was received.
A permission/privilege check failed.
The device’s current mode/state prohibits the
execution of the requested service.
To Next Page
Loading...
