12
TK 61009-12-OP-EN
WWaarrnniinngg
HHaazzaarrddoouuss VVoollttaaggee!!
Never work alone on high voltage circuits in the refrigeration unit. Another
person should be nearby to shut off the unit and provide aid in the event of
an accident. If there is a risk of energized electrical contact, arc, or flash,
technicians MUST put on all PPE in accordance with OSHA, NFPA 70E, or
other local, state, or country-specific requirements for arc flash protection
PRIOR to servicing the unit. NEVER PERFORM ANY SWITCHING,
DISCONNECTING, OR VOLTAGE TESTING WITHOUT PROPER ELECTRICAL
PPE AND ARC FLASHING CLOTHING. ELECTRICAL METERS AND
EQUIPMENT MUST BE PROPERLY RATED FOR INTENDED VOLTAGE.
WWaarrnniinngg
HHaazzaarrddoouuss VVoollttaaggee!!
Danger of electrocution! Disconnect the connection cable before you
replace the ColdCube™ Connect fuse.
WWaarrnniinngg
PPeerrssoonnaall PPrrootteeccttiivvee EEqquuiippmmeenntt ((PPPPEE)) RReeqquuiirreedd!!
In the event of an electrical accident, all required PPE should be near the
work area in accordance with OSHA, NFPE 70E, or other local, state, or
country-specific requirements for a Category 3 risk.
WWaarrnniinngg
RRiisskk ooff IInnjjuurryy!!
Do not make rapid moves when working on high voltage circuits in the
refrigeration unit. Do not grab for falling tools because you might
accidentally touch a high voltage source.
NNoottiiccee
EEqquuiippmmeenntt DDaammaaggee!!
Disconnect your equipment and all other electric devices from the battery
before you connect the battery to a quick charging device. Over-voltage can
damage the electronics of your equipment.
SSaaffeettyy IInnffoorrmmaattiioonn
To Next Page
Loading...