TK 61009-12-OP-EN
11
Electrical Hazards
DDaannggeerr
HHaazzaarrddoouuss VVoollttaaggee!!
Risk of fatal injury from electric shocks! Do not touch exposed cables with
your bare hands. This especially applies when operating the ColdCube™
Connect from an AC power supply.
WWaarrnniinngg
HHaazzaarrddoouuss VVoollttaaggee!!
Treat all wires and connections as if they were high voltage until a meter
and wiring diagram indicate otherwise. Only use tools with insulated
handles. Never hold uninsulated metal tools near exposed, energized
conductors. If there is a risk of energized electrical contact, arc, or flash,
technicians MUST put on all PPE in accordance with OSHA, NFPA 70E, or
other local, state, or country-specific requirements for arc flash protection
PRIOR to servicing the unit. NEVER PERFORM ANY SWITCHING,
DISCONNECTING, OR VOLTAGE TESTING WITHOUT PROPER ELECTRICAL
PPE AND ARC FLASHING CLOTHING. ELECTRICAL METERS AND
EQUIPMENT MUST BE PROPERLY RATED FOR INTENDED VOLTAGE.
WWaarrnniinngg
LLiivvee EElleeccttrriiccaall CCoommppoonneennttss!!
Control circuits used in your equipment are low voltage (12 or 24 VDC). The
voltage is not dangerous but the large amount of electric current
(amperage) from alternator and battery can cause severe burns if
accidentally shorted to ground with metal objects, such as tools. Do not
wear jewelry, watches, or rings because they increase the risk of shorting
out electrical circuits and damaging the equipment or causing severe burns.
WWaarrnniinngg
RRiisskk ooff IInnjjuurryy!!
The unit power plug must be clean and dry before connecting it to a power
source.
SSaaffeettyy IInnffoorrmmaattiioonn
To Next Page
Loading...