28
TK 61009-12-OP-EN
SSaammppllee ooff TTiicckkeett oonn SSLLXXee SSppeeccttrruumm
Figure 6. Example with I3 configured as door sensor and I4 configured as
humidity sensor
1.
Setpoint at header shows setpoint at moment of printing ticket.
2.
Input 4 is configured as humidity
3. Zone 1: Defrost Start
4.
Zone 2: Set point has been changed from -18 to -29 (old setpoint > new
setpoint)
5.
Zone 3:
• Has been switched OFF (old setpoint > OFF)
• Has been switched ON (OFF>new setpoint)
6. Zone 1: Defrost End
7.
TouchLog switched ON
8.
Door sensor (zone 2) from unit has been opened
9.
Door sensor (zone 2) from unit has been closed
BBaassiicc OOppeerraattiioonnss
To Next Page
Loading...