23-50 Energy Log Resolution
Option: Function:
Select the desired type of period for logging of consumption. Hour of
Day [0] , Day of Week [1] or Day of Month [2]. The counters contain the
logging data from the programmed date/time for start (par.23-51
Period
Start) and the numbers of hours/days as programmed for (par.23-50 En-
ergy Log Resolution).
The logging will start on the date programmed in par.23-51
Period
Start, and continue until one day/week/month has gone. Last 24 Hours
[5], Last 7 Days [6] or Last 5 Weeks [7]. The counters contain data for one
day, one week or five weeks back in time and up to the actual time.
The logging will start at the date programmed in par.23-51
Period Start.
In all cases the period split will refer to Operating Hours (time where
frequency converter is powered up).
[0] Hour of Day
[1] Day of Week
[2] Day of Month
[5] * Last 24 Hours
[6] Last 7 Days
[7] Last 5 Weeks
Note
The frequency converter has no back up of the clock function and the set date/time will reset to default
(2000-01-01 00:00) after a power down unless a Real Time Clock module with back up is installed. Consequently
the logging will be stopped until date/time is readjusted in par.0-70
Date and Time. In par.0-79 Clock Fault it is
possible to program for a Warning in case clock not has been set properly, e.g. after a power down.
23-51 Period Start
Range: Function:
0 N/A* [0 - 0 N/A] Set the date and time at which the Energy Log starts update of the coun-
ters. First data will be stored in counter [00] and start at the time/date
programmed in this parameter.
Date format will depend on setting in par.0-71
Date Format and time for-
mat on setting in par.0-72
Time Format.
Note
When mounting an Analog I/O MCB 115 option card, a battery back up of the date and time is included.
Parameter Description
TR200 Programming Guide 229
To Next Page
Loading...
