Cleaning and Storage
163
Do not get water near the following
places:
•
Air intake duct
• Any visible electrical components
• Brake cylinders and brake calipers
• Handlebar switch housings
• Steering head bearings
• Instruments
• Oil filler cap
• Rear bevel box breather (if equipped)
• Rear of headlights
• Seats
• Suspension seals and bearings
• Under the fuel tank
• Wheel bearings.
Note
Use of soaps that are highly alkaline will
leave a residue on painted surfaces, and
may also cause water spotting.
Always use a low alkaline soap to aid
the cleaning process.
Washing
To wash the motorcycle, do the
following:
•
Make sure that the motorcycle
engine is cold.
•
Prepare a mixture of clean, cold
water and mild automotive cleaner.
Do not use a highly alkaline soap as
commonly found at commercial car
washes because it leaves a residue.
•
Wash the motorcycle with a sponge
or soft cloth. Do not use abrasive
scouring pads or steel wool. They
will damage the finish.
•
Rinse the motorcycle thoroughly
with clean, cold water.
To Next Page