Instruments
27
Warning
If the traction control is not
functioning, care must be taken when
accelerating and cornering on wet/
slippery road surfaces to avoid rear
wheel spin.
Do not continue to ride for longer
than is necessary with the engine
management system Malfunction
Indicator Light (MIL) and traction
control warning lights illuminated.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked.
Hard acceleration and cornering in this
situation may cause the rear wheel
to spin resulting in loss of motorcycle
control and an accident.
If traction control is switched on:
•
Under normal riding conditions the
TC indicator light will remain off.
•
The TC indicator light will flash
rapidly when the traction control
system is working to limit rear
wheel slip during periods of hard
acceleration or under wet or
slippery road conditions.
If traction control is switched off:
•
The TC indicator light will not
illuminate. Instead the TC disabled
warning light will be illuminated.
Note
Traction control will not function if there
is a malfunction with the ABS system.
The warning lights for the ABS, traction
control and the MIL will be illuminated.
Traction Control (TC) Disabled
Warning Light
The TC disabled warning light
should not illuminate unless
traction control is switched
off or there is a malfunction.
If the warning light becomes illuminated
at any other time while riding, it
indicates that the traction control
system has a malfunction that requires
investigation.
Turn Signals
When the turn signal switch is
turned to the left or right, the
indicator warning light will
flash on and off at the same
speed as the turn signals.
Hazard Warning Lights
To turn the hazard warning lights on
or off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched off, until the
hazard warning light switch is pressed
again.
To Next Page
Loading...
