Unify OpenScape CP110 - Software Update; Care and Cleaning Instructions; Online Documentation; Location of the Telephone

Software update
During a software update, the phone must not be disconnected from the power
supply unit or the LAN. An update action is indicated by messages on the display
and by flashing LEDs.
Care and cleaning instructions
l
Never spray the phone with liquids as the penetrating fluids can lead to mal-
functions or may damage the device.
l
Do not use substances such as alcohol, chemicals, solvents or scouring
agents, as these substances can lead to surface damage.
l
Clean the phone with a soft and slightly damp cloth.
Online documentation
This document along with additional information is available online at:
https://www.unify.com/ àSupport.
Technical notes, current information about firmware updates, frequently asked
questions and lots more can be found on the Internet at: https://wiki.unify.com/.
Location of the telephone
l
The telephone may only be operated using the LAN cabling internally in the
building. The device should be connected to the IP infrastructure using a
shielded LAN cable: Cat-5 for 100Mbps or Cat-6 for 1000Mbps. Make sure
in the building installation that this cable shielding is earthed.
l
The telephone is designed for operation in a protected environment within
a temperature range of 5°C to 40°C.
l
Do not install the telephone in a room where large quantities of dust accu-
mulate; this can considerably reduce the service life of the telephone.
l
Do not expose the telephone to direct sunlight or any other source of heat,
as this is liable to damage the electronic components and the casing.
l
Do not install the telephone in bathrooms or shower rooms.
Important information 3