Unify OpenScape CP110 - Page 80

Other settings and functions 80
l
Lock telephone/Unlock telephone, code *66/#66, see "Locking the tele-
phone to prevent unauthorized use" à page 70
l
Change PIN, code *93, see "Saving your PIN code " à page 71
l
Send Message/Display Messages, code *68/#68, see "Sending a message"
à page 46
l
Absence text on/Absence text off, code *69/#69, see "Leaving an absence
text " à page 48
l
Ringing group on/Ringing group off, code *81/#81, see "Activating or deac-
tivating a group call" à page 65
l
Join hunt group/Leave hunt group, code *85/#85, see "Activating or deac-
tivating a group call" à page 65
l
Suppress call ID/Restore caller ID, code *86/#86, see "Caller ID sup-
pression" à page 70
l
Waiting tone off/Waiting tone on, code *87/#87, see "Muting the call wait-
ing tone " à page 29
l
Open door, code *61, see "Accepting calls from the entrance phone and
opening the door" à page 38
l
Door opener on/Door opener off, code *89/#89, see "Accepting calls from
the entrance phone and opening the door" à page 38
l
DND on/DND off, code *97/#97, see "Turning do not disturb on and off" à
page 69
l
Silent ringing on/Silent ring. off, code *98/#98 "Turning silent ringing on
and off " à page 69
l
Speed dial, code *7, see "Making calls using system speed-dial numbers " à
page 45
l
Associated serv., code *83, see "Activating functions for another phone" à
page 79
Prerequisite: Your phone supports tone dialling (DTMF) or you can switch your
phone to tone dialling. The phone is not connected to OpenScape Business.
Establish a connection to OpenScape Business. Enter the phone number.
Wait for the continuous tone (if necessary, switch phone to tone dialling) and enter
the internal phone number assigned to you and the corresponding PIN code.
Enter the code (only required if programmed in the system).
Wait for the dial tone and enter the code, for example *97 for DND on. If neces-
sary, make further entries; refer also to the user guide for dial pulse or DTMF
phones.
l
Optionally, dial the external phone number.
You can only perform one function or establish one outgoing connection at a
time. The connection is cleared as soon as the function is successfully activated.
In case of an external call, the connection is cleared as soon as one of the call
partners hangs up.