44
Restore Factory Defaults. This will set all Print alignment and other calibration settings back to factory
defaults.
Cartridge Settings. Here you can adjust the frequency of certain maintenance operations. Increasing the
value of “Seconds between Maintenance Spits” will decrease ink usage but could also cause poor quality
printing.
Increasing of Pages between Maintenance Wipes will speed up printing but could also cause poor quality
printing.
Check the Suppress Alignment message to prevent the window from appearing which prompts you to
align the cartridge every time a new cartridge is installed. Skipping the alignment is faster but can result
in poor print quality.
Stock Feed Settings. Adjust these settings only if directed to do so by Tech Support.
Calibrate the paper sensor if you are receiving TOF errors. The calibration process will prompt you to
remove all paper/stock from the printer before calibrating.
To Next Page
Loading...
