90
Present Options (Uncheck Cutter Enabled)
• Do not present. In this mode, the label stock does not move after the last label is printed.
This means that part of the last label printed is still in the printer. This should be used only if you
have a label rewinder attached.
• Present after no activity. This setting will present (feed all printed labels past the tear-off point)
at the end of a print job if the printer does not receive another print job within one second of the
last print job in the queue. You can use this feature to present at the end of a multi-copy job, a
multi-page job, or multiple individual jobs in the queue.
To Next Page
Loading...
