ALTERNATOR
REASSEMBLY
General
DRESS
ROTOR LEADS
AWAY
FROM PULLER
REMOVING REAR BEARING
The general reassembly instructions are reverse order to the procedures given for disassembly.
Therefore, only information pertaining to special reassembly requirements
will be covered in this
section.
Install Rear Bearing
Place rotor
on
a press as shown in illustration below. Choose a driver sleeve that exerts pressure
on inner race only and press bearing
on
rotor shaft until it contact shoulder. New replacement
bearings should be used whenever bearing is removed during repair procedures or when bearing
is rough, dry or noisy.
BLOCK
REAR
BEARING
ROTOR~
\
"
--PRESS
DRIVER
-SLEEVE
INSTALLING REAR BEARING
96
To Next Page
Loading...
Need help?
General
